Difference between revisions of "OutputAttributes/hydrology/en"

Latest revision as of 22:25, 17 February 2017

[edit] Output-Attributes

Output Attribute, Output Options

This section describes the types of selection and elements that should be included in the results output.

[edit] Views for processing the Output-Attributes

This view consists of the following four windows:

Nodes

Selecting the nodes which are to taken into account for the result output.

Sub catchments

Selecting the sub-catchments which are to taken into account for the result output.

Reservoir Strands

Selecting the reservoir strand which are to taken into account for the result output.

Output options

Select the available output files of a sub-catchments, a node or a reservoir strand as well as giving a water balance file as result output (see Figure Output Attribute Output Options').

To get calculation results for a model node, a sub-catchment or a reservoir basin strand, the attributes of the results must be set in the respective subjects table. The number of selected elements is optional. In addition, in the output settings, a general selection of available result types for each element in the table is available. For each selected model element, the respective time series of the same subfolder of simulations are stored after successful calculation. The results are depending on the selection of the following available result files:

1. Available output files in a sub catchment::

• Temperature
• Precipitation
• Snow height
• Total surface runoff
• Surface runoff, naturally
• Surface runoff sealed,
• Interflow
• Baseflow
• Ground water flow
• Ground water storage
• Evapotranspiration

2. Available output files of a reservoir strand:

• Storage time series
• Storage overflow

3. Available output files of a node:

• Total discharge

4. Total files:

• Outflow water balance